An Overview of Drill and Fill Insulation

When most people picture the insulation installation process, their minds go to a traditional rolled insulation process, where bails of insulation are carried into an attic or other room, unrolled and positioned between support beams of a home, where they’re stapled in place or secured in some other fashion. While this is still a common installation method today, other, more effective and efficient insulation methods are also being used, including the drill and fill method.

Drill and fill installations pertain to spray insulation in West Lorne, ON and represent one of the quickest, most encompassing ways to insulate the walls of a home, done from the outside. Take a look at a quick overview of the process:

1. Siding is removed from a home in the area where the drill and fill process will take place. Or, the spray foam insulation installation is undertaken before any siding is installed, to eliminate the extra step of taking it off and replacing it after.
2. Holes are drilled into the wall of a home, spaced equidistantly horizontally across the entire area being filled with insulation. These holes will later be capped and sealed.
3. Spray foam insulation in West Lorne, ON is prepared. The foam comes packaged in large bricks and must be broken down into smaller pieces before it can be blown into a space.
4. Once the foam insulation has been broken down appropriately, it is then blown into the walls of a home through the holes that were previously drilled. The foam accumulates to an appropriate density until each area of the wall is filled.
5. When the insulation is done being blown into a home, the filling holes are capped and sealed to prevent foam from escaping.
6. Siding is replaced or installed over the wall to create the final façade of the building, completely hiding the filling holes.

The process of drill and fill insulation takes significantly less time than other traditional methods of insulation installation and can equate to an overall lower cost to a homeowners for this reason. However, despite its lower cost and quicker installation time, spray foam insulation boasts some of the best efficiency ratings of any insulation type, over fiberglass and other traditional materials.

Perhaps the biggest and best benefit to a drill and fill insulation installation, however, is its noninvasiveness: the interior of a home remains untouched during the installation process. And, with siding to cover the sealed filling holes, there is absolutely no sign of installation that can be seen when the job is completed.

With mountains of benefits weighed in tandem with low costs and quick installation, drill and fill is becoming one of the most popular and effective choices for insulation installation in West Lorne, ON. For more information about this method and its benefits, contact an insulation professional in your area and schedule a consultation to gauge its feasibility for your home.